Mi cesta

convertidor CAN BUS

Delivery Time
2-3 Days
59,00 €
Incl. 21% VAT
Please note: The installation is very simple. Nevertheless, due to the nature of the intervention required by the module, it should be done by a specialist.

Many new vehicles are becoming increasingly familiar with digital CAN BUS technology that is not compatible with commercially available audio devices. This CAN BUS Converter converts digital Can Bus data into analog signals. Universally suitable for many vehicles with Can Bus technology. The adapter automatically recognizes the car's type after installation, allowing the installation of any kind of electronics accessories, navigation devices, car radios, hi-fi devices, tempo controls, fleet management, etc.

The following cables must be connected:

Continuous plus 12V - yellow
Mass - black
Can high - pink
Can low - gray

The following signals are generated:

Ignition plus 12V - red
Reverse gear - green
Lighting - orange
Handbrake - blue
Speedometer signal - purple
commissioning:

a) Close continuous plus 12V + ground + the two CAN lines
b) Switch on the ignition
c) The diode should flash red while the adapter is checking the CAN configuration of the vehicle.
d) Adapter looks for the right configuration for about a minute.
e) LED is green when the adapter has found the correct configuration.

Compatible with European vehicle models with inside or outside CAN BUS:

Alfa Romeo
Audi
BMW
Citroen
Fiat
ford
Lancia
Mercedes
Opel
Peugeot
Porsche
Renault
rover
SEAT
Skoda
Smart
Volvo
VW
Please note:
The installation is very simple. Nevertheless, due to the nature of the intervention required by the module, it should be done by a specialist.

Más Información
tiempo de tramitación 2-3 Days